Cornhole Carry Case Differences






  • Economy Series - This is sold only in a black, open top model for regulation 2x4 boards and is imported. This is the black, open topped carry case that is the most affordable series carry case. They can not be custom made, nor custom sized since imported in bulk. This series is best used for boards with 1x3 or 1x4 sides rather than heavier 2x4 sided boards. Heavy 2x4 sided boards are best carried by our deluxe model due to the shoulder strap taking on much of the load. This cheaper series is now only available under the supplies section of STLCornhole.com, item #015B. Limited availability.


  • Deluxe (Premium) Series Generation 1 (GEN1) - These were sold in any single color, dual color or triple color, had strong carry handles, shoulder strap, zippered top and could be made in any size needed. These were custom made in the USA. This model was discontinued on October 1st, 2012 and replaced with the below GEN2 model due to customer input improvement request.


  • Deluxe (Premium) Series Generation 2 (GEN2) - These were our top of the line carry cases until July 30th, 2013 when we made a small adjustment to the size (see below GEN3 details). This is the same as the GEN1 shown above, but with the following improvements per past customer requests: 4" longer handles, plus reinforced lower, inside corners. The GEN2 sizing is still available upon special request (read below).


  • Deluxe (Premium) Series Generation 3 (GEN3) - Starting July 30, 2013, these are now our top of the line carry cases and the best that money can buy anywhere, period. This is the same as the GEN2 shown above, but with the following improvement per customer requests: To accomodate both 1/2" topped and 3/4" topped boards, we increased the size of our carry case by 1" in the width and length. So, our regulation deluxe carry case is now sized 25x50x10" and our tailgate sized case is sized 25x38x10". The GEN2 was too tight for a 3/4" topped set of boards. This adjustment allows for a roomier case. If you want the best of the best cornhole carry case, then this is it! IF YOU STILL WANT THE GEN2 SIZE, THEN WE CAN STILL MAKE THAT FOR YOU UPON REQUEST AT NO EXTRA CHARGE. The custom order check out form for these deluxe carry cases is located at the bottom of the main page. NOTE: If you have 1"x3" sided ACO type boards, then you will want our thinner 25"x50"x8" deluxe carry case. You must email and request that 8" special size or you will receive the standard 10" wide model.


    REMEMBER! The easiest way to put your boards in your carry case is via the upside down method shown here.


  • HOME




    This is a StevenKing.biz website